Topic: Using RLink-Pro with a REva board

To Use RLink-Pro with a REva board where a RLink is allready embedded you have to connect the RLink-Pro to your Reva board and connect the USB Wire to your RLink-Pro.

Here is a picture of the connections to make in your situation...

ftp://www.raisonance.com/pub/forum/Connect_RLinPRO_on_REva3/Connect_RLinkPRO_on_REva3.JPG

In this configuration it is the RLink-Pro that is working so it is normal that the BUSY LED of the embedded RLink does not turn OFF, because this RLink's USB is not connected to the PC. It's the BUSY LED of the RLink PRO that must turn ON and then OFF.

If that doesn't work, please make sure that you are using the latest versions of the software (Ride7 and RKit-ARM), and if the problem persists please contact the Raisonance support and tell us exactly which error message you receive, during which operation, etc.

Last edited by Philibert (2010-07-21 14:39:16)