Topic: Using "RX BUFFER" property to receiver less then a byte of data

I am using the SendTransparentCommand to send a command to a Type A card.  The particular command that I send to the card returns a 6 bit value.  When I try to get the card response from the RX BUFFER I do not get any result.

Is it possible to retrieve data from the card when that data is less then a byte?

  • Yann
  • Member
  • Offline

Re: Using "RX BUFFER" property to receiver less then a byte of data

If you launch a trace record with RGPA, do you see the PICC 6bit response ?

Re: Using "RX BUFFER" property to receiver less then a byte of data

Yes, I do record a trace when doing this and it does indicate the card is actually sending data back.

Re: Using "RX BUFFER" property to receiver less then a byte of data

Any ideas about this?

  • Yann
  • Member
  • Offline

Re: Using "RX BUFFER" property to receiver less then a byte of data

Can you please send your product serial number at "SC-support@raisonance.com".
You can find it in : RGPA interface : Acquisition Tool -> Select Tool -> Configure -> Serial Number